The Ultimate Guide To Ft Myers Commercial Sprinkler Systems

Whether it’s design, installation, maintenance, or testing – DynaFire has the Fire & Life Safety solutions you need. Here’s what you need to know about Ft Myers commercial sprinkler systems.

 

Fire sprinkler systems save lives and property. A recent NFPA report found that in properties with a sprinkler system installed, the death rate per 1,000 fires was 87% lower than properties that did not have an automatic extinguishing system. In this blog, we will discuss Ft Myers commercial sprinkler systems, but if you don’t want to wait until the end to contact us for more information, stop what you’re doing and give us a call now!

 

Fire Sprinkler System Types

In order for Ft Myers commercial sprinkler systems to protect against fires, they need to be well-designed for the property and building occupancy type. There are four main types of sprinkler system:

  • WetFt Myers Commercial Sprinkler Systems
  • Dry
  • Preaction
  • Deluge

 

A wet system is used in most buildings, and it has pipes that are filled with water at all times. If there is a sprinkler activation, the water will discharge to extinguish the fire

 

A dry system is typically used in buildings that lack climate control and insulation, such as warehouses or garages. This system uses supervisory switches to maintain air pressure in the pipes, preventing water from flowing through them until a signal is sent to the monitoring panel. In the event of a fire, the sprinkler heads will open, release the air pressure, and allow water to flow through the system and extinguish the fire.

 

A preaction system is very similar to a dry-pipe system, since it uses air-filled instead of water-filled piping. The difference between this and a dry system is that it requires the detection of heat, smoke, or flame in addition to the opening of the sprinkler head before it will discharge. This is meant to avoid accidental discharges that could damage high-value assets that are housed in some buildings.

 

A deluge system is similar to a preaction system in that it requires activation after a smoke detector or other device sends a signal to a monitoring panel. However, with a deluge system the sprinkler heads are always open, allowing for extremely quick reaction times. These systems are often used in highly flammable or hazardous environments.

 

Ft Myers Commercial Sprinkler Systems: What Causes Sprinkler Activation?

Most Ft Myers commercial sprinkler systems are activated by heat detection. When a fire starts, it creates hot gases that rise to the ceiling of the room. A fire sprinkler’s heat-sensing element will then be heated until it meets the thermal element’s temperature threshold and activates the sprinkler head. Some sprinkler systems, such as a preaction system, will have multiple modes of fire detection.

 

If the first thing you think of when you imagine a sprinkler system activation is a downpour of water, you’re sadly mistaken (except for that deluge system of course). Most sprinkler system activations involve only a targeted few sprinkler heads.

 

DynaFire Has All Of Your Ft Myers Commercial Sprinkler Systems Needs Covered

Whether you’re looking for expert design, installation from NICET-certified technicians, maintenance, or testing, you won’t need to look any further than DynaFire. Contact us today to schedule your next service!

Prev post
Next post

Our website is currently undergoing maintenance, and you may encounter temporary issues. We appreciate your patience and understanding as we work to serve you better.

X
No products in the cart.